Management Tasks - GE MDS SD Series Technical Manual

Logging Out
To exit the Device Manager, click
is terminated.
NOTE To maintain security, it is best to log-out of the Device Manager as soon as you are done
working with it. If you do not log out, the session automatically ends after 10 minutes of
inactivity.

6.2 Management Tasks

Table 11 shows a listing of commonly-needed tasks and the appropriate sections of the Device
Manager to refer to. The table can be used as a quick reference before consulting the more de-
tailed screen information which follows in this section.
Task
If you wish to...
Category
View top-level unit information (Owner
Name/Message, Unit Number, IP Address,
Serial No., Firmware version, Run time, Alarm
presence, etc.)
View Radio Performance data (Power Output,
Signal-to-Noise Ratio, Received Signal
Strength, DC Input voltage, operating
temperature)
View Serial No., Model 1 (software), Model 2
(hardware) version, Firmware Version, Build
Date
View Bootloader version information, Active
Firmware Image, Firmware Version level
View Alarm/Event information, I/O Statistics,
Ethernet Statistics
34
in the upper right hand side of any screen. The session
Logout
Table 11. Device Manager Quick Reference
SD Series Technical Manual
Refer to this
Screen/Section
Overview, Page 33
Maintenance & Status>>
Radio Performance,
Page 71
Or: Overview>>
Health & Maintenance
Summary (shows uptime),
Page 33
Overview>>
SD Summary, Page 33
Maintenance & Status>>
Firmware Utilities>>
Version Information,
Page 77
Maintenance & Status>>
Alarm Summary, Page 69
Maintenance & Status>>
Performance, Page 71
MDS 05-4846A01, Rev. I