Lamp Control Via DMX
To enable or disable the Intimidator Hybrid 140SR lamp from being controllable through DMX, follow the
instructions below:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to select Setup.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Lamp Setting.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to select Off Via DMX.
7.
Press <ENTER>.
8.
Use <UP> or <DOWN> to select NO or YES.
9.
Press <ENTER>.
On if DMX is On
To set the Intimidator Hybrid 140SR lamp to be on when a DMX signal is present, do the following:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to select Setup.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Lamp Setting.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to select On if DMX On.
7.
Press <ENTER>.
8.
Use <UP> or <DOWN> to select NO or YES.
9.
Press <ENTER>.
Off if DMX is Off
To set the Intimidator Hybrid 140SR lamp to be off when there is no DMX signal present, follow the
instructions below:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to select Setup.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Lamp Setting.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to select Off if DMX Off.
7.
Press <ENTER>.
8.
Use <UP> or <DOWN> to select NO or YES.
9.
Press <ENTER>.
Ignition Delay at Power On
To set the amount of time after power on before the Intimidator Hybrid 140SR lamp turns on, do the
following:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to select Setup.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Lamp Setting.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to select Ignition Delay.
7.
Press <ENTER>.
8.
Use <UP> or <DOWN> to increase or decrease the delay time, from 000–255 (0 seconds to 255
seconds).
9.
Press <ENTER>.
Warning! When power linking this product, lamp ignitions must be offset to avoid
high inrush currents. The ignition delay of the first product in a power linking chain
must be set to no less than five seconds. The ignition delay of each subsequent
product in the chain must be at least five seconds more than the previous product.
Page 19 of 29
Intimidator Hybrid 140SR User Manual Rev. 2
O
PERATION