Table of Contents
Advertisement
O
PERATION
Main Level
SETTING
PASS CODE
CALIBRATION
Passcode)
INFO
DMX Personalities
This setting allows you to choose a particular DMX personality.
1.
Go to the SETTING main level.
2.
Select PERSONALITY.
3.
Choose the desired personality (UNO, DOS, or STD.P).
•
See the
each personality.
•
Make sure that the starting addresses on the various products do not overlap due
to the new personality setting.
DMX Control
In this mode, each product will respond to a unique starting address from the DMX controller. All products
with the same starting address will respond in unison.
1.
Select a DMX personality as shown in
2.
Set the Running Mode:
a.
Go to RUN MODE main level.
b.
Select DMX 512.
•
Note: For information on the SLAVE option, see
3.
Set the starting address:
a.
Go to ADDRESS main level.
b.
Select the starting address (001–512).
The highest recommended starting address for each DMX mode is as follows:
DMX Personality
UNO
DOS
STD.P
Ovation FD-205WW User Manual Rev. 1
Programming Levels
PWM
POSE1
(Enter
CALZ
POSE2
VERSION
UID
RDM
LABEL
DMX Control
section for the highest starting address you can select for
DMX Personalities.
600Hz
1200Hz
2000Hz
PWM Selection
4000Hz
6000Hz
25KHz
0-255
Sets min/max position of zoom
V__
Software Version Number
_ _ _ _ _
Unique Identification Code
_ _ _ _ _
Product Model
Master/Slave
Mode.
DMX Address
512
511
508
Description
Page 13 of 22
Advertisement
Table of Contents
