Table of Contents
Advertisement
Main Level
LED
Frequency
Back Light
Key Lock
Information
Reset
Factory
Configuration (DMX)
Use DMX configurations to operate the product with a DMX controller.
DMX Personalities
This setting allows you to choose a particular DMX personality.
1.
Go to the DMX Channel main level.
2.
Select the desired personality (6 Ch, 8 Ch, or 13Ch).
•
See the
each personality.
•
Make sure that the starting addresses on the various products do not overlap due
to the new personality setting.
DMX Control
In this mode, each product will respond to a unique starting address from the DMX controller. All products
with the same starting address will respond in unison.
1.
Select a DMX personality as shown in
2.
Set the starting address:
a.
Go to DMX Address main level.
b.
Select the starting address (001–512).
The highest recommended starting address for each DMX mode is as follows:
DMX Personality
13
8
6
Page 14 of 22
Programming Levels
600Hz
1200Hz
2000Hz
4000Hz
6000Hz
25kHz
On
10S
20S
30S
On
Off
Fixture Hours
Version
UID
Battery
No
Yes
DMX Control
section for the highest starting address you can select for
DMX Personalities.
Description
Selects the PWM output frequency
Display backlight always on
Turns off display backlight after 10 sec of
inactivity
Turns off display backlight after 20 sec of
inactivity
Turns off display backlight after 30 sec of
inactivity
Turns the passcode on or off
Shows total product hours
Shows installed software version
Shows product UID
Shows battery level
Reset all settings to factory defaults
DMX Address
500
505
507
COLORdash Par-H12 IP User Manual Rev. 1
O
PERATION
Advertisement
Table of Contents
