Master/Slave Mode - Chauvet INTIMIDATOR HYBRID 140SR User Manual

Master/Slave Mode

The Master/Slave mode allows a single Intimidator Hybrid 140SR product (the "master") to control the
actions of one or more Intimidator Hybrid 140SR products (the "slaves") without the need of a DMX
controller. The master product will be set to operate in either Stand-Alone mode or with the IRC-6, while
the slave products will be set to operate in Slave mode. Once set and connected, the slave products will
operate in unison with the master product.
Configure the products as indicated below.
Slave products:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Slave.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select from Slave1, Slave2, Slave3, or Slave4.
• Select Slave1 for 100% synchronized actions.
• Select Slave2, Slave3, or Slave4 for a delayed show, creating a wave effect.
7. Connect the DMX input of the first slave product to the DMX output of the master product.
8. Connect the DMX input of the subsequent slave products to the DMX output of the previous slave
product.
9. Finish setting and connecting all the slave products.
Master product:
1. Set the master product to operate in Stand-Alone mode or with the IRC-6.
2. Make the master product the first product in the DMX daisy chain.
• Configure all the slave products before connecting the master to the daisy chain.
• Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the master.
• Do not connect more than 31 slaves to the master.
Page 23 of 29 Intimidator Hybrid 140SR User Manual Rev. 2
O
PERATION