Table of Contents
Advertisement
Dimmer Profiles
LED Frequency
Back Light
Fixture Hours/
Software Version
Configuration
(DMX)
DMX
Personalities
DMX Control
COLORdash S-Par 1 User Manual Rev. 2
This setting determines how fast the output of the COLORdash S-Par 1 changes when you
modify the values of the red, green, blue, amber, and dimmer faders. This setting provides four
different options to simulate the dimming curve of an incandescent lighting product.
1. Go to the Dimmer Mode main level.
2. Select a dimmer curve (OFF, Dimmer 1, Dimmer 2, or Dimmer 3).
OFF:
The output is proportional (linear) to the dimmer and RGBA channel values.
Dimmer 1–3: The output follows the dimmer and RGBA channel values based on the
corresponding dimmer curve, DIM1 being the fastest and DIM4 the slowest.
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the
COLORdash S-Par 1.
1. Go to the LED Frequency main level.
2. Select PWM Frequency (600Hz, 1200Hz, 2000Hz, 4000Hz, or 25Khz).
This
setting
allows
COLORdash S-Par 1's display stays on after the last button is pressed on the control panel.
1. Go to the Back Light main level.
2. Select On (remains on), 10S (10 seconds), 20S (20 seconds), or 30S (seconds).
This option displays the total number of hours the fixture has run, and the installed software
version.
1. Go to the Information main level.
2. Select Fixture Hours or Version.
Use DMX configurations to operate the product with a DMX controller.
This setting allows you to choose a particular DMX personality.
1. Go to the DMX Channel main level.
2. Select the desired personality (4 Ch, 6 Ch, or 11Ch).
·
See the
DMX Values
personality.
·
Make sure that the starting addresses on the various products do not overlap due to
the new personality setting.
In this mode, each product will respond to a unique starting address from the DMX controller. All
products with the same starting address will respond in unison.
1. Select a DMX personality as shown in
2. Set the starting address:
a. Go to DMX Address main level.
b. Select the starting address (001–512).
The highest recommended starting address for each DMX mode is as follows:
DMX Personality
11
6
4
for
selection
of
the
section for the highest starting address you can select for each
DMX
amount
of
time the
Personalities.
DMX Address
502
507
509
Operation
backlight on the
-13-
Advertisement
Table of Contents
