Fig. 1001 Preferred Position Of Tt-V Heater For Storage And Transport - Webasto Thermo Top V Workshop Manual

Thermo Top V
10 Packing, Storage and Shipping
10.1 General
If the heater or its components are sent to Webasto AG for
testing or repair, it must be cleaned and packed in such a
way that it is protected against damage during handling,
transport and storage.
10.2 Storage
Heater position
The heater can be stored in any positions. There are no re-
strictions here.
Heaters must always be stored in the delivery packaging or
in similarly suitable packaging in closed rooms!
After being removed from the delivery packaging, the heat-
ers should make contact only on the aluminium parts (for
position, see Fig. 1001). The type label and the surface of
the heater must be protected against damage with a suita-
ble surface (e.g. cardboard).
Fig. 1001 Preferred position of TT-V heater for storage
and transport
The storage temperature should be at least -40 °C and a
maximum of 60 °C.
During storage the heater should be covered and must be
protected from dust, dirt and moisture.
The heater may not come into contact with chemicals or
their vapours, e.g. fuel, battery fluids or brake fluids.
No dirt, water or chemicals may enter into the openings of
the heater during storage (see above).
The fuel pipe must be protected from side impact loads
which lead to pipe deformation
Visit www.butlertechnik.com for more technical information and downloads.
www.butlertechnik.com
Packing, Storage and Shipping
10.3 Transport
The heater can be transported in any position.
Heaters must always be transported in the delivery packag-
ing or in similarly suitable packaging!
The electrical contacts must generally be protected against
mechanical damage.
The temperature should be at least -40 °C and a maximum
of 60 °C during transport.
The heater must be protected against environmental influ-
ences, such as rain, snow, stone impact, etc., during trans-
port.
IMPORTANT
If an entire heater is returned, then it must be completely
drained of operating fluids. It must be ensured that no fuel
or coolant can escape during packing and/or shipping. The
coolant connection piece and the fuel connection must be
sealed off with blind plugs.
1001