General Information - Webasto Thermo Top V Workshop Manual

1 Introduction
• Must be put into operation at least once a year for 10
minutes with the engine cold and the lowest fan speed
selected.
• Must be checked by a professional every 2 years, at the
commencement of the heating period.
Warranty and liability claims:
• A failure to observe the vehicle-specific installation in-
structions/operating instructions and the information
contained in them will result in the warranty being void-
ed by Webasto. The same applies if repairs are carried
out incorrectly or with the use of parts other than gen-
uine spare parts. This will result in the invalidation of the
type approval for the heater and therefore of its ho-
mologation / EC type licence. In addition, we shall also
exclude our liability for slightly negligent violations of
duties, provided damages from injury to life, body or
health or guarantees are not affected or claims in ac-
cordance with the applicable product liability laws are
not concerned. Also unaffected by this is the liability for
the violation of duties which, when fulfilled, enable the
proper execution of the contract in the first place and in
the regular fulfilment of which the customer may place
its trust. The same applies to violations of duties by our
vicarious agents.
1.4.2 Statutory regulations governing installa-
tion
For the Thermo Top V heater there are homologation
approvals in accordance with the EC Directives 72/245/EEC
(EMC) and 2001/56/EC (heating) with the EC approval num-
bers:
e1*72/245*2006/96*1232*__
e1*2001/56*2006/119*0018*__
Installation is governed above all by the provisions in Annex
VII of Directive 2001/56/EC and the regulations in accord-
ance with the installation instructions.
The specifications of this Directive are binding in the scope
of the Basic Directive EEC/70/156 and/or EC/2007/46 (for
new vehicle models from 29/04/2009) and should also be
observed in countries in which no special regulations exist.
102
Visit www.butlertechnik.com for more technical information and downloads.
NOTE:

1.4.3 General information

Some vehicle manufacturers have provided components like
the auxiliary/additional heater with component protection.
On these vehicles the new unit must be activated after
replacing the unit at a specialist workshop of the respective
manufacturer.
Please note that this is generally linked to low additional
costs for the customer.
www.butlertechnik.com
Thermo Top V