Panasonic SA-BT300PX Service Manual page 62

9.28.4. Slide Cam
Step 1 Perform the step "9.28.3. Pulley Gear, Belt".
Step 2 Remove the Sheet.
Step 3 Disconnect the 3 FFCs.
Step 4 Remove the 2 Screws (B) and the Angle.
Step 5 Peel off Copper Sheet from FFC (A) and remove the
Drive P.C.B..
Caution: Though the Drive P.C.B. is not supplied as
replacement parts, it must be removed for after disassem-
bling.
Step 6 Open the connector lock, and disconnect the FFC.
Step 7 Remove the 2 Screws (C), and remove the Traverse
Base Ass'y with spreading the 2 hooks to the direction of
arrows.
Step 8 Remove the Slide Cam.
9.28.5. Mid Gear, Drive Gear and Loading
Motor
Step 1 Perform the step "9.28.4. Slide Cam".
Step 2 Remove the Mid Gear and Drive Gear.
Step 3 Remove the Screw (D) to remove the Loading Motor.
Step 4 Remove the Screw (E), and remove the SW P.C.B. with
the Loading Motor.
Remove the 2 soldering points, and remove the Loading Motor.
62