Disassembly
Removing and Replacing the Slider Assembly
G
G
38
1.
Remove battery cover, battery, memory card, rear housing, daughter board
assembly, transceiver board assembly, keypad, and front housing as described
in the procedures.
The hydraflex can be easily damaged. Use extreme caution during this procedure.
2.
Use the T5 driver to remove the 2 slider screws from the slider assembly.
Slider screw
Figure 35. Removing the Slider Assembly Screws
3.
Use the disassembly tool to lift only the top end of the slider inner assembly
out of the slider outer assembly. Leave the bottom end attached.
4.
Rotate the slider outer assembly upward, to expose the keypad flex connector
which is still attached to the slider outer assembly (see Figure 36 on page 39.
When removing the slider, ensure that the earpiece is not damaged because of any
remaining adhesive.
February 19, 2008
Slider screw
Z6m/Z6tv CDMA
v463353
6809513A80-B