Disassembly
Removing and Replacing the Transceiver Board Assembly
G
G
24
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
1.
Remove the battery cover, battery, memory card, antenna, rear housing as
described in the procedures.
The flexible printed cable (FPC) (flex) is easily damaged. Exercise extreme care when
handling.
2.
Carefully slide the end of the disassembly tool under the slider Hydra Flex
(HF) connector and rotate the tool slightly to lift the connector from its socket
on the transceiver board. See Figure 14. Pay special attention to the electrical
components around the connector. Do not touch any components with the
black stick.
Figure 14. Disconnecting the Flex From the Transceiver Board
February 19, 2008
Z6m/Z6tv CDMA
Hydra flex connector
6809513A80-B
v463258