Motorola MOTORIZR Z6tv Service Manual page 71

Level 1 and 2 Service Manual
6809513A80-B
2. Place thumb over top edge of push bar as shown. Open the slider so that the
bottom tip of the slider is on the arc above the "0" key on the XCVR keypad.
3. Release the slider by quickly lifting thumb and letting push bar slide beneath
it. To guarantee a clean release, lift thumb directly upward or in opposite
direction of slider motion. Never allow thumb to move in the same direction as
slider motion.
4. If the slider fails to reach its fully closed position within 2 seconds after release,
the phone fails this test. The speed of the motion is irrelevant.
5. Place thumb over top edge of push bar as shown. Open the slider so that the
bottom tip of the slider is below the "5" key but above the arc on the XCVR
keypad.
6. Release the slider by quickly lifting thumb and letting push bar slide beneath
it. To guarantee a clean release, lift thumb directly upward or in opposite
direction of slider motion. Never allow thumb to move in the same direction as
slider motion.
7. If the slider fails to reach its fully open position within 2 seconds after release,
the phone fails this test. The speed of the motion is irrelevant.
8. All failed phones must be quarantined and reworked.
Smoothness Test
1. Hold the phone at a 45 degree angle with one hand.
2. Place thumb over top edge of push bar and fully open and close the slider
minimum of 2 times, line operator's fingers must be in contact with push bar
at all times during sliding.
3. If the line operator feels the sliding is bad, the phone fails this test.
4. Examples of things that qualify for bad slider are:
• Rattling sound
• Clicking noise
• Tight sliding
• Scratch sound
• sluggish movement
• Bumpy movement
5. All failed phones must be quarantined and reworked.
February 19, 2008
Disassembly
71