Removing And Replacing The Main Lens - Motorola MOTORIZR Z6tv Service Manual

Level 1 and 2 Service Manual

Removing and Replacing the Main Lens

G
6809513A80-B
It is mandatory that the following special tools be used when following
this procedure:
Z6m/tv Lens Press Tool - part number 0-00-00-40879
1. Insert the disassembly tool into the gap between the lens and the slider outer
housing and gently pry upward.
Figure 72. Removing the Display Lens
2. Remove any excess adhesive from the slider outer housing.
3. To replace, prepare the display lens for installation to the slider outer, bend
the liner back in two areas to avoid interference when assembling.
4. Before placing the lens into the outer housing, move the medallion blue liner
tab away from the lens resting area.
5. Lens is to be inserted at top of slider outer and dropped down (the bottom edge
- closest to keypad should be inserted last) to ensure bonding.
6. Turn the slider outer with the inside of the housing facing up and keep it flat
on the table surface. Bend the side keypad tabs to the inside by inserting the
flat side of the disassembly tool flush behind the keypad tab
7. Bend the tab towards the inside of the housing to form a 30 degree angle.
Repeat this step for the other side tab.
8. Once the initial bend has been established next directly press down on the tabs
with the black stick. Repeat this step for the other tab.
February 19, 2008
Lens
Disassembly
v503131
61