Table of Contents
Advertisement
Level 1 and 2 Service Manual
Removing and Replacing the Display Assembly
6881040B65
1.
Remove the rear housing cover, SIM, endo assembly, front endo housing, and
battery, as described in the procedures.
2.
Use the disassembly tool to carefully release the 4 metal display latches on
each side of the display assembly as shown in Figure 10.
3.
Carefully lift the display assembly away from the transceiver board as shown
in Figure 10.
Figure 10. Removing the Display Assembly
4.
To replace, align the display assembly with the printed circuit board.
5.
Gently press the display assembly latches into position while holding the
display assembly in position.
6.
Replace the battery, front endo housing, endo assembly, SIM, rear housing
cover as described in the procedures.
August 20, 2002
Disassembly
DISPLAY ASSEMBLY
DISPLAY ASSEMBLY LATCH
DISASSEMBLY
TOOL
020194
020194o
27
Advertisement
Table of Contents
Troubleshooting
