NordicTrack NTSY14016.0 User Manual page 9

2. Align a Slide Bracket (60) along the centers
of the wall studs. Using your pencil, mark the
locations of the slots on the wall studs. Then,
remove the Slide Bracket.
Repeat these actions for the other Slide
Bracket (60).
Using your drill, drill pilot holes in the marked
locations on the wall. Drill 1/4" pilot holes in
wood wall studs. Drill 7/8" pilot holes in metal
wall studs. IMPORTANT: The pilot holes must
be drilled straight and perpendicular to the
center of the wall stud.
Wood Wall Studs. If you are installing the
Slide Bracket (60) in wood wall studs, see
the upper drawing. Locate the 3/8" x 3" Screws
(103) and the 3/8" x 1 1/4" Washers (104). Align
a Slide Bracket with two sets of pilot holes.
Using your ratchet or drill, tighten four Screws
with four Washers into the Slide Bracket and the
pilot holes. Start all the Screws, and then fully
tighten them.
Metal Wall Studs. If you are installing the
Slide Bracket (60) in metal wall studs, see
the center drawing. Locate the M10 x 100mm
Toggle Bolts (105). Align a Slide Bracket with
two sets of pilot holes. Using your ratchet or drill,
tighten four Toggle Bolts into the Slide Bracket
and the pilot holes; make sure to orient the
Toggle Bolts so that the wings (A) will open
vertically. Start all the Toggle Bolts, and then
fully tighten them.
Repeat these actions for the other Slide
Bracket (60).
Make sure that each Slide Bracket (60) is
flush with the wall and that the 3/8" x 3"
Screws (103) or the M10 x 100mm Toggle
Bolts (105) are firmly tightened. Pull firmly on
each Slide Bracket. There must not be any
movement or play in the Slide Brackets.
Then, go to step 4.
2
Wood Studs
103
104
103
Metal Studs
105
105
9
60
104
A
60
A