NordicTrack NTSY14016.0 User Manual page 24

HOW TO TIGHTEN THE ROPES
The ropes may stretch over time. If there is slack in
the ropes before resistance is felt, the ropes should be
tightened. To tighten the ropes, first unplug the power
adapter, and then follow the steps below.
See assembly step 11 on page 15. Remove the
Front and Rear Bottom Covers (67, 109) from the
bottom of the strength system.
See assembly step 7 on page 13. Remove the four
Slide Covers (63) or Wall Covers (64) from the Slide
Brackets (60).
See assembly step 6 on page 12. Loosen the four
M10 x 20mm Bolts (102).
See assembly step 5 on page 15. Remove the
four M10 x 20mm Patch Screws (101) and M10 Star
Washers (119) from the four Tower Brackets (62).
Then, with the help of one or two other persons, move
the strength system away from the wall.
See EXPLODED DRAWING B on page 31. Identify
the Rear Shroud (59). Remove the four #8 x 3/4"
Screws (86) and the Rear Shroud from the strength
system.
See the drawing at the right. Locate a Pulley
Carriage (46). Remove the M8 Jam Nut (106), the
M8 x 33mm Bolt (112), and the Small Pulley (55) from
the upper hole in the Pulley Carriage.
Reattach the Small Pulley (55) to the other hole in the
Pulley Carriage (46). Make sure that the Rope (130)
and the Small Pulley move smoothly.
Locate the other Pulley Carriage (46) and repeat
these actions.
Next, see assembly steps 5 to 7 and reattach the
strength system to the brackets. Then, see assembly
step 11 and reattach the covers. Plug in the power
adapter.
24
130
106
46
46
55
112