NordicTrack NTSY14016.0 User Manual page 10

3. See the upper drawing. Slide a Wall Bracket
(61) onto each side of a Slide Bracket (60).
Align the Slide Bracket (60) assembly along
the centers of the wall studs. Adjust the Wall
Brackets (61) as needed. Using your pencil,
mark the locations of the slots on the wall studs.
Then, remove the Slide Bracket assembly.
Repeat these actions for the other Slide
Bracket (60) assembly.
Using your drill, drill pilot holes in the marked
locations on the wall. Drill 1/4" pilot holes in
wood wall studs. Drill 7/8" pilot holes in metal
wall studs. IMPORTANT: The pilot holes must
be drilled straight and perpendicular to the
center of the wall stud.
Wood Wall Studs. If you are installing the
Slide Bracket (60) assembly in wood wall
studs, see the second drawing. Locate the
3/8" x 3" Screws (103) and the 3/8" x 1 1/4"
Washers (104). Align a Slide Bracket assembly
with two sets of pilot holes. Using your ratchet or
drill, tighten four Screws with four Washers into
the Slide Bracket assembly and the pilot holes.
Start all the Screws, and then fully tighten
them.
Metal Wall Studs. If you are installing the
Slide Bracket (60) assembly in metal wall
studs, see the third drawing. Locate the
M10 x 100mm Toggle Bolts (105). Align a Slide
Bracket assembly with two sets of pilot holes.
Using your ratchet or drill, tighten four Toggle
Bolts into the Slide Bracket assembly and the
pilot holes; make sure to orient the Toggle
Bolts so that the wings (A) will open verti-
cally. Start all the Toggle Bolts, and then fully
tighten them.
Repeat these actions for the other Slide
Bracket (60) assembly.
Make sure that each Slide Bracket (60) is
flush with the wall and that the 3/8" x 3"
Screws (103) or the M10 x 100mm Toggle
Bolts (105) are firmly tightened. Pull firmly on
each Slide Bracket. There must not be any
movement or play in the Slide Brackets.
Then, go to step 4.
3
61
Wood
Studs
103
104
103
Metal
Studs
105
105
10
60
61
60
104
A
60
A