Toshiba e-STUDIO163 Service Manual page 143

[K] Pickup roller
(1) Take off the drawer.
(2) Take off the process unit.
P.11-9 "[A] Process unit"
(3) Rotate the pickup roller shaft counter-clock-
wise.
Note:
Because the tension is applied to the pickup
roller shaft by the pickup clutch when it is
rotated counter-clockwise, be sure to hold
the shaft while replacing the roller.
(4) Release 2 latches each to take off 2 pickup
rollers.
Notes:
• Be sure to install the pickup roller in the
correct direction when reassembling it.
• The pickup roller also can be taken off in
the following procedure.
1. Take off the process unit.
P.11-9 "[A] Process unit"
2. Take off the drawer.
3. Remove 1 screw and take off the
dump heater cover.
4. Take off 2 pickup rollers by releasing 2
latches each.
December 2005 © TOSHIBA TEC
Fig. 10-31
Dump heater cover
Fig. 10-32
Pickup roller
Fig. 10-33
e-STUDIO163/203 PAPER FEEDING SYSTEM
10 - 17
Pickup roller
10