Toshiba e-STUDIO163 Service Manual page 96

Note:
Be sure to hold the CIS unit drive belt-1 to
move the CIS unit.
(3) Lift up the CIS unit, disconnect 1 connector
on the bottom of the CIS unit, and then take
off the CIS unit.
Note:
When handling the CIS unit, take care not to
contarminate the lens with fingerprints or
such.
[F] CIS case
(1) Take off the CIS unit.
P.6-11 "[E] CIS unit (CIS)"
(2) Remove 1 screw and take off the belt stop-
per.
Note:
When installing the belt stopper, install it so
that the protrusion of the stopper fits in the V-
groove on the inside of the CIS unit drive
belt-1.
e-STUDIO163/203 SCANNER
6 - 12
CIS unit drive belt-1
Fig. 6-18
CIS unit
Fig. 6-19
Belt stopper
CIS unit
drive belt-1
Fig. 6-20
December 2005 © TOSHIBA TEC