Disassembly And Replacement - Toshiba e-STUDIO163 Service Manual

9.5

Disassembly and Replacement

[A] Main motor (M3)
(1) Take off the rear cover.
P.2-22 "[J] Rear cover"
(2) Disconnect 1 connector, remove 2 screws,
and then take off the main motor.
[B] Toner motor (M2)
(1) Take off the rear cover.
P.2-22 "[J] Rear cover"
(2) Disconnect 1 connector, remove 2 screws,
take off the toner motor with the bracket, and
then remove 1 bushing and 1 gear.
e-STUDIO163/203 DRIVE UNIT
Connector
Tonner motor Connector
Bracket Bushing
9 - 6
Main motor
Fig. 9-3
Gear
Fig. 9-4
December 2005 © TOSHIBA TEC