Toshiba e-STUDIO163 Service Manual page 146

(3) Remove 1 E-ring, 1 gear, and 1 pin from the
registration roller.
[P] Registration roller (metal)
(1) Take off the Process unit.
P.11-9 "[A] Process unit"
(2) Take off the transfer unit.
P.11-17 "[N] Transfer unit"
(3) Take off the registration roller clutch.
P.10-18 "[L] Registration roller clutch
(CLT1)"
(4) Remove 1 clip, 1 bushing and then take off
the registration roller (metal) while sliding it to
the rear side.
(5) Remove 1 E-ring, 1 bushing and then take
off 1 pin and 1 gear.
e-STUDIO163/203 PAPER FEEDING SYSTEM
Registration roller (metal)
10 - 20
E-ring
Gear
Pin
Registration roller (rubber)
Fig. 10-40
Clip
Registration roller (metal)
Fig. 10-41
E-ring
Gear
Pin
Fig. 10-42
December 2005 © TOSHIBA TEC
Bushing
Bushing