Toshiba e-STUDIO163 Service Manual page 207

[I] Center thermistor / Side thermistor / Edge thermistor (THMS1/THMS2/THMS3)
(1) Take off the fuser roller.
P.13-16 "[G] Fuser roller"
(2) Remove each 1 screw of the thermistors,
and then take off each thermistor by releas-
ing its harness out of the harness clamp.
Note:
When installing the thermistors, do not mix
up the installation positions of the side ther-
mistor and the edge thermistor by telling
them apart by the length of their harnesses.
[J] Fuser thermostat (THMO1)
(1) Take off the fuser roller.
P.13-16 "[G] Fuser roller"
(2) Remove 2 screws and take off the fuser ther-
mostat.
December 2005 © TOSHIBA TEC
Thermistor
Fig. 13-28
Side thermistor
Center thermistor
Fig. 13-29
Fig. 13-30
13 - 19
Edge thermistor
Fuser thermostat
e-STUDIO163/203 FUSER / EXIT UNIT
13