Table of Contents
Advertisement
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten until the last step.
Nylon lock nuts will not fully screw onto bolts, they must be wrench tighten to fully go
on.
1A. Attach Right Frame (B) to Left Frame (C) using:
4 - (#2) M10x25mm Hex Head Bolt
8 - (#3) M10 Flat Washer
4 - (#4) M10 Nylon Lock Nut
1B. Attach Center Frame (A) to Left and Right Frames (B & C) using:
4 - (#1) M10x75mm Hex Head Bolt
8 - (#3) M10 Flat Washer
4 - (#4) M10 Nylon Lock Nut
2 - ( F ) Steel Plate
8
Advertisement
Table of Contents
