Quick Start - Baldor VS1MX Installation & Operating Manual

1.3 Quick Start (Quick Start Guide MS762 is also available separately.)
See Recommended Tightening Torques in Table 4-1.
Power Up Procedure (Refer to Chapter 3, 4 and 5 for additional details.)
1. Remove all power from the control.
2. Couple the motor to its load.
3. Verify freedom of motion of motor shaft.
4. Verify the motor coupling is tight without backlash.
5. Connect input control wires and output control wires, See Figure 1-2.
6. (Switched Version) Place Direction Command switches in OFF Position.
(Keypad version) Connect a control switch between terminals 1 and 2 ensuring that the contact is open (drive disabled)
7. Connect Power & Motor wires to the control, See Figure 1-1.
8. Turn power on. Be sure there are no faults. For switched version, place the Power On/Off switch in ON position.
9. Set the following parameters for the values displayed on the motor nameplate:
P-01 Motor Rated Voltage
P-02 Motor Rated Current
P-03 Motor Rated Frequency
P-04 Motor Rated Speed
10. (Switched Version) set P07 Start/Stop Source to 0.
(Keypad version) set P07 Start/Stop Source to 1 or 2.
11. Verify the holding brakes if any, are properly adjusted to fully release and set to the desired torque.
12. (Switched version) Run the drive from the front panel controls.
(Keypad version) Enable the drive by closing the switch between control terminals 1 & 2. Run the drive from the keypad.
13. Select and program additional parameters to suit your application, see Chapter 7.
The control is now ready for use. If a different operating mode is desired, refer to Chapter 7 Parameter Descriptions and
Chapter 8 Customizing for your Application.
MN762
Figure 1-1 Power & Motor Terminal Locations
Size A, B, C
(VS1MX10PS5 shown
as an example)
Size A, B, C
(VS1MX22 shown
as an example)
Size A
L1/L L2/N L3
Size B & C
L1/L L2/N L3
U V W
+
U V W BR
Introduction 1-3