Keypad Mode (P-07 = 1 Or 2) - Baldor VS1MX Installation & Operating Manual

8.2.2 Keypad Mode (P-07 = 1 or 2)

Table 8-2 Parameter P-08 Control of Digital Inputs when P-07=1 or 2
P-08 Digital In 1 (Term. 2)
Open Stop
0, 1, 5,
8-12
Closed Run
Open Stop
2
Closed Run
Open Stop
3*
Closed Run
Open Stop
4
Closed Run
Open Stop
6*
Closed Run
Open FWD Stop
7*
Closed FWD Run
*Remote Up and Remote Down are MOP (E-Pot) controls. These provide Speed Increase and Decrease inputs to allow MOP
operation. (Keypad controls remain active)
P-08 = 3, 6 or 7 Note: Connect external PTC Motor Thermistor or similar user contact to Digital Input 3.
P-08 = 7 Note: Closing both Digital Input 1 and 2 = Fast Stop (P33).
8-4 Customizing Your Application
Digital In 2 (Term. 3)
Open KeypadSpeedRef
Closed Remote Up*
Open KeypadSpeedRef
Closed Remote Up*
Open KeypadSpeedRef
Closed Remote Up*
Open KeypadSpeedRef
Closed Remote Up*
Open FWD Run
Closed REV Run
Open REV Stop
Closed REV Run
Figure 8-2 Keypad Mode Example Wiring
Keypad mode P07 = 1 or 2, P08 = 0
+24V Output
1
O: Stop (disable)
2
C: Run (enable)
C: Remote Up
3
C: Remote Down
4
+10V Output
5
O: Forward
6
C: Reverse
0V
7
Digital In 3 (Term. 4)
Open KeypadSpeed Ref
Closed Remote Down*
Open KeypadSpeedRef
Closed Remote Down*
Open Trip (Ext Trip)
Closed Run
Open KeypadSpeedRef
Closed Analog Input 1
Open Trip (Ext Trip)
Closed Run
Open Trip (Ext Trip)
Closed Run
Note: When P-07 = 1 or 2 and P-08 = 3, 6, 0r 7
Motor Thermistor & E-Trip Connection
Trip - Run
Suitable for PTC Motor Thermistors
of type PT100 or similar.
Trip Level set at 2.5
Only operational using E-trip terminal
function on Digital Input 3
Analog In 1 (Term. 6)
Open Forward
Closed Reverse
Open KeypadSpeedRef
Closed Preset Speed 1
Open KeypadSpeedRef
Closed Remote Down
Analog Input 1
Keypad Speed
Open
Ref
Closed Preset Speed 1
Open KeypadSpeedRef
Closed Preset Speed 1
1 +24V Output
4 Digital Input 3
K Ohms
MN762