Entering The Sealing Parameters - Pfaff 8310-041 Instruction Manual

Preparation
●
●
9

Entering the sealing parameters

.03
The direct input and alteration of sealing parameters is only possible in Manual or Dynamic
Sealing. In Programmed Sealing the direct input of the sealing parameters is not possible.
The alteration must be made in the appropriate sealing program, see Chapter 10.05 Crea-
ting/altering a sealing program. Depending on the selected production type and the corres-
ponding pre-settings (power sealing/amplitude sealing) the following parameters can be alte-
red directly:
- Sealing power or sealing amplitude, see Chapter 9.03.01
- Sealing speed, see Chapter 9.03.02
- Roller pressure, see Chapter 9.03.03
●
●
●
24
Select the desired sequence number on the number block.
Confirm selection and quit selection menu, die production type "Programmed Sealing
with sequence program" is activated.
Switch on the machine, see Chapter 8.03, Switching the machine on/off.
Call up program selection.
Call up manual sealing.
The screen displays described below only appear if manual sealing is selected.
If dynamic sealing is selected, the sealing speed input is different, see Chapter
9.03.02 Entering the sealing speed.
Power sealing (standard)
In Programmed Sealing the direct input of the sealing parameters is not possib-
le. The alteration must be made in the appropriate sealing program, see Chapter
10.05 Creating/altering a sealing program.
Amplitude sealing