Table of Contents
Advertisement
ROLAND
Rev. 1.0
9.2 Memory faults (faults no. 1 to 24)
1
Error while writing to the EEPROM.
The acknowlegde signal does not arrive within
the expected time.
2
Error while writing to the EEPROM.
No storage in memory possible.
3
Parameter "Program Number" is out of range
(> 255).
5
Parameter "Dimensions" is
neither "mm" nor "inch".
6
Parameter "Measuring mode" is
- neither "external single measurement"
- nor "external continuous measurement"
- nor "demo mode".
8
Parameter "Language" is not realistic.
9
Parameter "Sensor Switch Box" is not realistic.
12
Parameter "Measurement start" is not realistic.
15
Parameter "Teach-limit FE" is not realistic.
16
Parameter "sensor type" is not defined.
17
System parameter "Output 0-1-2" is
out of range.
18
System parameter "External adjustment" is
not realistic.
19
System parameter "FE measurement" is
not realistic.
7
Parameter "Zero-Adjust" is not realistic.
20
Memory error XX.
Unrealistic parameter in program XX.
The program has been deleted.
21
Memory error XX.
Unrealistic parameter in program XX.
Several programs have been deleted.
ROLAND ELECTRONIC GMBH · Otto-Maurer-Str. 17 · D-75210 Keltern · Telefon (0049) (07236) 9392-0 · Telefax (0049) (07236) 9392-33
OPERATING INSTRUCTIONS
DOUBLE SHEET DETECTOR R1000 UDK20
The EEPROM is defective.
The EEPROM is defective.
The memory errors 3 to 19 (except error 7)
can be redressed as follows:
- Select the defective system parameter
in the system configuration.
- Press the ENTER key, the corresponding
setting will the blink.
- Correct the value with the "Arrow" keys.
- Store the value with the ENTER key.
- Switch the unit off and on again,
in order to check the new value.
Perform Zero-adjust.
Create a new program and store it.
Switch unit off and on.
If error re-appears, change EEPROM.
Since the numbers of the deleted programs
cannot be indicated, check all programs.
Switch unit off and on.
If error re-appears, change EEPROM.
Page 97
Table: Memory faults
Advertisement
Table of Contents
