Table of Contents
Advertisement
R O L A N D
Page 102
For a 2PW-control unit with up to two sensors:
1.
Check that no sheet is in front of the sensor resp. the sensors
Press the MENU key, switch to "change" and confirm with ENTER key
2.
3.
Enter password
4.
Switch to "program parameter" and confirm with ENTER key
5.
Check that no sheet is in front of the sensor resp. the sensors
Switch to "zero adjust" and confirm with ENTER key
6.
7.
Select "zero adjust: separate" or "zero adjust: common"
7.1
If "zero adjust: sepatate", then confirm with ENTER
7.1.1 Display: "zero adjust S1: on / remove sheet"
If zero adjusts desired, then ENTER , or
if zero adjusts not desired, then activate "off" and confirm with ENTER
7.1.2 Display: "zero adjust S2: off"
If zero adjusts not desired, then press ENTER , or
if zero adjusts is desired, then activate "on" and press ENTER
7.2
If "zero adjust: common", then confirm with ENTER , all connected sensors are zero adjusted.
8.
The display "zero adjust: active" appears, and then "zero adjust: off"
Leave programming with the MENU key.
9.
10.2 Exchange of a Control unit
Exchange with help of the RPP-software (only with C-versions):
The UDK20 provides for backup and re-writing the equipment parameters via the RS232 interface, with help
of the provided RPP-software.
Exchange without help of the RPP-software:
After exchanging the equipment, the original system configuration must be restored. Therefor, the form
„System Configuration" in chapter „Technical Documents" (which had been filled out during set-up) can be
used. If this form is not available or filled out, the information on the system configuration must be retrieved
from the equipment documentation.
ROLAND ELECTRONIC GMBH · Otto-Maurer-Str. 17 · D-75210 Keltern · Telefon (0049) (07236) 9392-0 · Telefax (0049) (07236) 9392-33
OPERATING INSTRUCTIONS
DOUBLE SHEET DETECTOR R1000 UDK20
B0048991
Advertisement
Table of Contents
