Table of Contents
Advertisement
2.3 Heat output adjustment
The valve supplied with the appliance has a HI/LO knob to control the heat output and flame height
(Figures 2 & 3).
2.4 Fan operation
The fan control knob is located behind the decorative doors, below the firebox and may be adjusted
to the following settings: OFF:
Variable Speed Setting: Turn the control to the desired setting. When the knob is turned fully
clockwise the fan will set to minimum speed.
Do not use this appliance if any part has been under water. Immediately call a qualified service
technician to inspect the appliance and to replace any part of the control system and any gas controls
which have been under water.
3.0 INSTALLATION
3.1 Installation and safety notes
Read all instructions before starting installation and follow them carefully during installation to ensure
maximum benefit and safety. Failure to follow these instructions will void your warranty and may
present a fire hazard. See the warranty at the back of this manual for disclaimers regarding improper
installation.
This fireplace insert and its components are tested and safe when installed in
accordance with this installation manual.
ELECTRICAL GROUNDING NOTE: A three-prong (grounding) plug, for your protection against
shock hazard, is provided and should be plugged directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding prong from this plug.
WARNING: Do not connect 120 VAC to the gas control valve or it's wiring, as this
will damage the valve.
3.2 Unpacking
Please check the appliance carefully for any damaged or missing components (specifically check the
glass condition). Report any problems to your dealer. This unit is shipped with the logs in a separate
package.
Turn the control fully counter-clockwise until the switch operates.
8
Advertisement
Table of Contents
