Table of Contents
Advertisement
4.4 Cleaning of gold plated surfaces
Take special care and DO NOT use chemical or abrasive cleaners. Wipe only with a soft damp
cotton cloth to maintain original brilliance. Do not clean plated surfaces when they are still hot.
CAUTION: Vigorous wiping may damage the gold finish.
4.5 Burner & pilot cleaning
Periodic cleaning is necessary for proper operation.
Refer to section 4.8, remove the burner, and check that the burner orifice is clean.
Visually inspect the pilot. Brush or blow away any dust, lint, or foreign debris. If the pilot orifice is
plugged, disassembly may be required to remove any foreign material from the orifice or tubing.
When the appliance is back in service, check the pilot flame pattern with the figures in Section 3.3.6.
For re-lighting, refer to the lighting instructions in Section 2.2.
4.6 Fan replacement & electrical schematic
"Caution: Label all wires prior to disconnection when servicing controls. Wiring errors can cause
improper and dangerous operation. Verify proper operation after servicing.
1.
Cut the gas supply to the valve assembly then disconnect the supply line at the valve.
2.
Open the decorative doors and remove the glass door and control panel
18a).
3.
Remove the burner (Figure 23).
4.
Remove the screws that secures the valve assembly in place, lift the assembly and pull
it out of the firebox to access the fan assembly (Figure 24).
5.
Finally remove the two (2) screws that secures the fan assembly and proceed with the
maintenance or replacement.
NOTE :
If the valve assembly gasket is damage during the removal process, it has to be
replaced by a new one.
(Figure
32
Advertisement
Table of Contents
