Phonetics SENSAPHONE EXPRESS II User Manual page 87

All monitored channels, including built-in monitoring features, shall allow keyboard
and remote touch-tone programming of pertinent operational data including, but not
limited to:
1.
accumulator)
2.
3.
4.
5.
6.
B. Outputs
The system shall have one built-in SPST latching 2A 250VAC relay output. The output
may be programmed to switch automatically on alarm or manually via keyboard or
Touch-Tone™ phone. Up to 16 additional relay output channels may be installed by
the user.
III. Communications Features
A. Telephone Specifications
The system shall connect to a standard 2-wire telephone line using pulse or tone
dialing methods, with loop start only. The system shall recognize ringer frequencies
from 16 to 60 Hz. No leased or dedicated lines shall be required. The system shall
also be capable of being used on the same telephone line as other answering de-
vices. Call progress detection shall ensure that the alarm dialout is not hindered by
no-answers or busy signals.
B. Telephone Numbers
The system shall be capable of dialing up to 48 telephone numbers, 40 digits each.
There shall be a capacity to program, retain and use three separate lists based on a
calling schedule of weekday, weeknight and weekend. Each list shall contain up to 16
phone numbers. In addition, individual phone contact lists may be programmed for
each input channel.
The system shall allow local keypad and remote touch-tone programming of the
following telephone dialing information:
1. Dialing method (Automatic, pulse, tone)
2. Retries on busy (0 to 15)
3. Message repetitions (0 to 10)
4. Maximum number of calls (0 to 65,535)
5. Call delay time (0 seconds to 12 hours)
6. Intercall delay time (0 seconds to 12 hours)
Sensaphone ® Express II User's Manual
80
Input type (NO/NC, 4-20mA and 0-5V analog, pulse count, thermistor, time
High and Low limits (-9999 to +9999)
Input recognition time (0 seconds to 12 hours)
Alarm reset time (0 seconds to 12 hours)
Phone Contacts list for each channel
Enable/disable for each channel to dialout for alarm