Outputs - Phonetics SENSAPHONE EXPRESS II User Manual

OUTPUTS [8]

Up to 16 outputs may be installed in Express II.
1. Manual - This type of output is turned on/off manually by
the user. It is available only if you purchased an output
card for the Express II. These cards look no different than
the Input cards you can add and are installed the same way.
2. Auto-any alarm - Output #0, which comes built into the
unit, can be switched on automatically when alarm recogni-
tion occurs, and off again when the alarm is acknowledged.
The condition causing the alarm may still exist, but the auto-
alarm will be off. (See Figure 11 for location of this Output
Relay.)
Outputs may be useful if you want to have equipment
hooked up to the Express II. For instance, if the unit is
monitoring temperature in a particular environment, you
might have a fan or heater hooked up to an output, which
you could switch on over the phone if the temperature
exceeded prescribed parameters.
See Chapter Four for more information on Outputs.
OUTPUT PARAMETERS
1) Press Program.
PROGRAM
2) Press Output.
TUV
8
OUTPUTS
3) Enter output number (0-16).
4) Press 1 for manual.
Press 1 for OFF.
Press 2 for ON.
5) Press 2 for automatic-any
alarm. Only for output # 0.
Chapter 5: Programming 41