Messages - Phonetics SENSAPHONE EXPRESS II User Manual

MESSAGES [4]

Recording your own messages provides a valuable, expedi-
tious communication link between the Express II and
service personnel.
Voice messages - Express II allows you to program your
own voice for the ID (identification) and dial-out alarm
messages. This means that when Express II calls you or
someone on your staff during an alarm, your personalized
voice message will indicate exactly which alarm condition
exists. Depending on what the input is monitoring, you might
program a warning message, or provide brief vital monitor-
ing data.
The voice message choices are:
1 - Record ID Message (default length: 10 seconds)
2 - Record Input Message (default length: 5 seconds)
3 - Record Output Message (default length: 5 seconds)
4 - Message length
The ID Message allows you to identify the Express II
and/or the system it's monitoring as the caller.
The Input Message is the alarm message correspond-
ing to each specific input that the Express II is monitor-
ing. You must program this by entering the number of
the Input (1-8 on the first card, etc.)to identify it, and
then recording the relevant alarm message for it.
The Output Message feature can only be used if you've
purchased and installed an Output Card in the Express
II.
Message length - This parameter determines how many
seconds long each message can be. A message can be 5,
7, or 11 seconds long. However, you can cut any message
short if you finish recording it, by pressing [Enter].
(Note: The shorter the message length, the better the
quality of the recording. We recommend that you program
this parameter to 5 seconds for optimum clarity.)
NOTE: Do not change the message length parameter
after you have recorded voice messages. If you do so,
you will automatically erase all programmed voice
messages and reset them to the default.
®
32 Sensaphone Express II User's Manual
MESSAGE PARAMETERS
Messages:
1) Press Program.
PROGRAM
2) Press Messages.
GHI
4
MESSAGES
Messages menu will then appear on
local display.
> 1- Record ID msg
2- Record input msg
3- Record output ms
4- Message length
4) Press 1 to record ID message.
Speak message after beep.
5) Press 2 to record input messages.
Enter the input number to which the
message corresponds.
Speak message after beep.
6) Press 3 to record output message.
Enter the output number to which the
message corresponds.
Speak message after beep.
7) Press 4 for message length.
Enter 5, 7, or 11.(the default is 5)
Messages can be cut short by
pressing Enter during recording.