Cisco 7960G Administrator's Manual page 73

Chapter 5 Monitoring Cisco SIP IP Phones
Table 5-1 CLI Commands (continued)
Command
show command keywords (continued)
SIP Phone> test {open | close | key { k1 ... k12 } |
onhook | offhook | show | hide}
How to Use the Command-Line Interface to Monitor Phones
Purpose
fsm—Current status of the Feature State Manager
•
function control blocks.
fsmdef—Current status of the Default Feature State
•
Manager data control blocks.
fsmcnf—Current status of the Conference Feature State
•
Manager call control blocks.
fsmxfr—Current status of the Transfer Feature State
•
Manager transfer control blocks.
• fim—Current status of the Feature Interaction Manager
control blocks (interface control blocks and state control
blocks).
gsm—Global State Manager status that includes these
•
parameters: vcm, lsm, fim, fsm, and gsm.
register—Current registration status of SIP lines.
•
• network—Network information, such as phone platform,
DHCP server, phone IP address and subnet mask, default
gateway, address of the TFTP server, phone MAC
address, domain name, and phone name.
config—Current flash memory configuration, including
•
network information, phone label and password, SNTP
server address, DST information, time and date format,
and input and output port numbers.
• personaldir—Current contents of the personal directory.
This command can be used only if the telnet_level
parameter is set to allow privileged commands to be
executed.
dialplan—Phone dial plan.
•
timers—Current status of the platform timers.
•
(Optional) running—Shows the running configuration.
•
all—Shows all.
•
Accesses the remote call test interface, allowing you to
control the phone from a remote site. This command can be
used only if the telnet_level parameter is set to allow
privileged commands to be executed. Keywords are as
follows:
open—Enables the use of the test functionality.
•
close—Disables the use of the test functionality.
•
Cisco SIP IP Phone Administrator Guide, Release 6.x and 7.x
5-5