Cabling The Phone Ports; C H A P T E R 2 Installing Cisco Ip 7960G/7940G Phone Hardware On The Desktop Or Wall - Cisco 7960G Administrator's Manual

Cabling the Phone Ports

Figure 2-1
Footstand adjustment Footstand adjustment
button raises and button raises and
lowers adjustment lowers adjustment
plate plate
Modify the handset rest so that the handset remains on the earpiece rest when the phone is vertical.
Step 3
a.
b.
c.
d.
Step 4 Insert two screws into a wall stud, matching them to the two screw holes on the back of the footstand.
The screw holes fit standard phone jack mounts.
Step 5 Hang the phone on the wall.
Cabling the Phone Ports
The Cisco MGCP IP phone has several ports on the back of the phone, shown in
Plug the appropriate equipment into the appropriate port.
Caution Consider use of an uninterruptible power supply (UPS). Without one, when you use either a local
transformer or inline power on the LAN, the phone is inoperable during a power outage. This affects
your ability to make emergency calls: 911 in USA and Canada, 999 in the UK, and 112 in mainland
Europe.
Use of a headset does not require an amplifier. However, it does require a coil cord to connect the headset
Note
to the headset port. For information on ordering compatible headsets and coil cords, refer to
http://cisco.getheadsets.com
Cisco SIP IP Phone Administrator Guide, Release 6.x and 7.x
2-2
Adjusting the Footstand
Cisco IP phone (rear view) Cisco IP phone (rear view)
Adjustment plate Adjustment plate
installation installation
screw holes (2) screw holes (2)
Remove the handset from the earpiece rest.
Locate the tab (handset wall hook) at the base of the earpiece rest.
Slide this tab out, rotate it 180 degrees, and reinsert it.
Place the handset on the earpiece rest.
or http://vxicorp.com/cisco.
Chapter 2 Installing Cisco IP 7960G/7940G Phone Hardware on the Desktop or Wall
Adjustment plate Adjustment plate
raises and lowers raises and lowers
phone vertically phone vertically
Figure 1-3 on page 1-5.