Power Off - Kenwood DPX-U5130 Service Manual

4.2 Production Test Mode
Press and hold [1] key and [3] key and reset.
4.2.1 Default condition when the mode is started
It shall be same as normal RST start in other settings than the following.
Difference in action Period to prohibit TEL/LINE MUTE immediately after activation
(normally 10seconds)
CD Mecha Initialize Action
Write-in to E2PROM when detecting a DC error
Demo Mode ON/OFF Setting Menu
Power supply during ACC OFF (Back Up On)
BEEP sound
Various setting value Volume
BASS BOOST/LOUDNESS
EQ
Fader/Balance
Volume Offset
DEMO Mode Setting
AUX Setting (Built-In-Aux)
BT speaker Setting
4.2.2 Mode structure
Some Test Modes change according to the current source.
The following table shows the current source in Set and the related test mode status.
Model source

POWER OFF

Standby
TUNER
SXM
CD
BT
USB
AUX
4.2.3 Mode content
Syscom shall display the following information after entering this mode. The operation shown below shall be workable.
Display content
4.2.4 STANDBY Test Mode Specification
Operation
Syscom version
display
BT Module version
display
1 (Toggle)
Media control part
version display
All lights ON
Details
-
STANDBY Test mode
TUNER Test mode
SXM Test Mode
CD Test mode
BT Test mode
USB Test mode
-
All lights ON
Display content
S Y S 0
B T S X X X X
M E D I A : x x
(No.WA063<Rev.003>)16/31
1 second
Prohibited
Prohibited
Prohibited
MUTE terminal turns OFF after 2 seconds
Beep with short-pressing in any functions
33 (-10dB)
OFF
NATURAL
Center
-6: for only SXM source
0: for the other sources
OFF
ON
ALL
Test mode
Details
xxx: Version (Micom)
1 -
BT Module version display
Media control part version display
x x
All lights ON (Switch with other display)
Details