Kenwood DPX-U5130 Service Manual page 19

Dual sized cd receiver
Hide thumbs Also See for DPX-U5130:
Table of Contents

Advertisement

4.2.6 Sirius XM Test Mode Specification
Perform a communication test with the Sirius XM Tuner SXV100. If the test result is OK, 1kHz signal is output from the internal tone
generator of the SXV100.
Without preconditions, in the test mode, start in a state of receiving 0ch.
Press the [RETURN] key to switch the signals in the order of L/R → L → R → OFF. (Default setting is L/R.)
• Volume setting in the Sirius XM source
The level of the internal tone generator output cannot be adjusted. If the Sirius XM source is selected in the test mode, set the VOL
offset to "-6".
Operation
Left & Right
Channel
Left Channel
RETURN
Right Channel
Off
Follow the specifications of the normal display if any channel other than 0ch is received.
4.2.7 CD Test Mode Specification
It shall be the same as normal RST start in other than the below setting.
Content
Playback track from top
Default for Display mode
4.2.7.1
Operations in CDDA playback
Operation
Special track up
Special track down
1 (Toggle) File type display
Special jump
3
operation
Special jump
4
operation
Special jump
5
operation
Special jump
6
operation
Display content
x
x
x
x
x
x
x
x
L
E
F
T
R
I
G
H
T
O
F
F
No.9
Play time
Display content
x
x
x
(No.WA063<Rev.003>)19/31
Details
xxxxxxxx: 8 characters Radio ID.
Output 1kHz signal for Left/ Right channel.
Output 1kHz signal for Left channel.
Output 1kHz signal for Right channel.
No Tone generator output (same as normal opera-
tion).
Details
Details
Pressed Track up depend on different cases.
Case 1: Track>8
No.9 → No.15 → No.10 → No.22 → No.12 → No.13
→ No.14 → No.9
Case 2: Track< 8
No.1 → No.2 → No.3 → Until Last Track
One-by-one Track down by sequence follow Track
No.
CDDA/ MP3/ WMA/ AAC Judgement Information
CD: CDDA track playback
MP3: MP3 file playback
WMA: WMA file playback
AAC: AAC file playback
Jump to No.28
(Scratch 0.7mm for MUSIC line vibration test)
Jump to No.14
(Damaged disc TCD-731RA Tr14)
Jump to No.15
Set Volume value at 27 (for error operation FCT
check of 20Hz 0dB DC protection)
Jump to No.9 if the other than track No.9 is playing.
Jump to No.22 if the track No.9 is playing.

Advertisement

Table of Contents
loading

Table of Contents