Kenwood DPX-U5130 Service Manual page 27

4.10 Security Code Force Delete mode (Only for European models)
While pressing and holding [ ] key, press [SEARCH] key for 3 seconds.
4.10.1 Mode transition method
Transit to this mode by pressing the above keys, and "- - - -" disappears.
4.10.2 Simplified forced deletion of the security code
Clear the security code by the following operations.
• Enter "KCAR" by using the remote control.
(1) Press the [5] key 2 times to display "K", then press the [ ] key.
(2) Press the [2] key 3 times to display "C", then press the [ ] key.
(3) Press the [2] key 1 time to display "A", then press the [ ] key.
(4) Press the [7] key 2 times to display "R", then press the [ ] key.
After (4), if the entered CODE is correct, the opening screen appears.
• If an incorrect remote control CODE is entered, the Security Code Force Delete mode is terminated, and the normal code-entry
screen appears.
*In this mode, the [VOL] key is not used for confirmation of the CODE.
*Pressing the [ ] key won't move the digit to the left.
*Cursor display or blinking display of the input digit do not appear.
Display content
C O D E
C O D E
C O D E
C O D E
C O D E
4.11 Diagnostic Data Mode Specification
In the SXM source, press and hold [RETURN] key and [ACCENT] key for 7 seconds.
(It is necessary to connect tuner box sold separately)
4.11.1 Default status immediately after the mode activation
It shall be same as the normal activation.
4.11.2 Mode structure
Diagnostic Data Mode is only enabled in Sirius XM source.
4.11.3 Mode content
Syscon shall display the following information after entering this mode.
Display content
D I A G M O D
4.11.4 Display mode available during Diagnostic Data Mode
In Diagnostic Data Mode, the display can be switch between Diagnostic Mode display and normal mode display using [DISP] key.
The default display mode upon activation is Diagnostic Mode display.
Operation
Diagnostic Mode
Display
DISP (Tog-
gle)
Normal Mode Dis-
play
Default display (no cursor, only "CODE" is displayed)
Input the 1st digit
Display the character by pressing the remote control key.
x
Press the [ ] key to confirm and move to the next digit.
Input the 2nd digit
Display the character by pressing the remote control key.
x x
Press the [ ] key to confirm and move to the next digit.
Input the 3rd digit
Display the character by pressing the remote control key.
x x x
Press the [ ] key to confirm and move to the next digit.
Input the 4th digit
Display the character by pressing the remote control key.
Press the [ ] key to confirm.
x x x x
OK: move to the opening screen
NG: move to the normal code-entry screen
The display is display for 1 second.
E
Display content
S I G
# # # # # # #
(No.WA063<Rev.003>)27/31
Details
Details
Default display in diagnostic mode.
X # #
Depending on display pattern in normal mode.
# # # # # #
Details