Kenwood DPX-U5130 Service Manual page 26

4.7 Version Display Mode
In the STANDBY source, while pressing and holding [RETURN] key, press [DISP] key.
4.7.1 Default condition when the mode is started
Same as normal start-up.
4.7.2 Mode structure
Version display mode can be executed independent of the current source.
4.7.3 Mode content
Syscom shall display the following information after entering this mode. The operation shown below shall be workable.
Display content
1 2 x x x x
4.8 FM/AM channel space switching mode
For the following bands, toggle switch (default ↔ background span) is possible by turning the Power (ON) while [1] and [5] keys are
pressed during the Power OFF.
Type Band
FM1 (MHz)
[While in the Test mode]
FM2 (MHz)
K
FM3 (MHz)
AM (kHz)
Type Band
FM1 (MHz)
[While in the Test mode]
FM2 (MHz)
FM3 (MHz)
M
MW (kHz)
SW1 (kHz)
SW2 (kHz)
4.9 Forced Power ON mode (Only for European models)
Press and hold [ENTER] key and [4] key and reset.
4.9.1 Mode transition method
While "- - - - " is being displayed, it is possible to turn the Power (ON) for 30 minutes by pressing the above keys. After 30 minutes,
reset is the only way to recover.
If temporary blackout, reset, Power OFF, or ACC OFF occurs in the forced Power ON mode, the forced Power ON mode is terminated.
Development name - Version (Micom)
- x x x
Range
87.5 - 108.0MHz 50kHz
87.5 - 108.0MHz 50kHz
87.5 - 108.0MHz 50kHz
530 - 1700kHz 10kHz
Range
87.5 - 108.0MHz 50kHz
87.5 - 108.0MHz 50kHz
87.5 - 108.0MHz 50kHz
531 - 1611kHz 9kHz
2940 - 7735kHz 5kHz
9500 - 10135 5kHz
11580 - 18135kHz
(No.WA063<Rev.003>)26/31
Details
Band
FM1 (MHz)
↔ [While in the Test mode]
Range
FM2 (MHz)
switching
FM3 (MHz)
AM (kHz)
Band
FM1 (MHz)
[While in the Test mode]
FM2 (MHz)
↔
FM3 (MHz)
Range
switching
MW (kHz)
SW1 (kHz)
SW2 (kHz)
Range
87.9 - 107.9MHz 200kHz
87.9 - 107.9MHz 200kHz
87.9 - 107.9MHz 200kHz
530 - 1700kHz 10kHz
Range
87.9 - 107.9MHz 200kHz
87.9 - 107.9MHz 200kHz
87.9 - 107.9MHz 200kHz
530 - 1700kHz 10kHz
2940 - 7735kHz 5kHz
9500 - 10135 5kHz
11580 - 18135kHz