Processor Unit - Furuno FCR-2829W Installation Manual

2. WIRING
Connection of Sub-display
A conventional remote display and/or FCR-2107 series radar can be connected to
J617 and J 618 in processor unit as sub-display. However, the GAIN and STC controls
function differently depending on J617 and J618. Refer to the tablet to connect sub-
displays.
Port Connector
J617 Overall gain
(FULL-LOG)
GAIN control The GAIN control functions.
STC control
J618 Overall gain
(SEMI-LOG)
GAIN control The GAIN control functions.
STC control
2.5

Processor Unit

2.5.1 How to connect cables to terminals on the processor unit
Use screws (M3x6, supplied) to attach the wiring plate 1 and wiring plate 2 assy to the
processor unit. Connect the cables shown below to the connectors at the front of the
processor unit. After the connection, bind cables to the appropriate fixing metal with
the cable ties (supplied).
For the cables from the monitor unit (type: DVI-D/D SLINK5M/10M (MU-190 only),
DSUB9P-X2-L5/10M) and ground wire, connect them to the processor unit directly
(without fixing to a wiring plate). Tighten the fixing screws on these connectors to pre-
vent disconnection from the processor unit.
Note: Connect the cables so that they do not interfere with the opening or closing of
the DVD tray.
2-18
Conventional remote display
Even if input video level is ad-
justed to 4 Vp-p, the gain is 8 dB
lower than that on the master ra-
dar.
The STC control functions.
When input video level is adjust-
ed to 4 Vp-p, the gain becomes
the same as that on the master
radar.
The STC control functions, how-
ever this control is added on the
signal adjusted by the master ra-
dar. So this port is not recom-
mended to use.
FCR-2107 series radar
The gain is 8 dB lower than that on
the master radar.
The GAIN control does not func-
tion.
The STC control does not function.
The gain is almost same as that on
the master radar.
The GAIN control does not func-
ton.
The STC control does not function.