Input/Output Data - Furuno FCR-2829W Installation Manual

5.

INPUT/OUTPUT DATA

The radar(s) must be interconnected to the following type approved sensors:
Gyrocompass meeting the requirements of the IMO resolution A.424(XI).
EPFS meeting the requirements of the IMO resolution MSC.112(73).
SDME meeting the requirements of IMO resolution MSC.96(72).
The radar may be interconnected via HUB-3000 to other FURUNO processing
units having approved LAN ports.
5.1 Radar Processor Unit
Input and output data are shown in the table below.
Input
Data
Heading signal
*: Data input cycle should be more than 40 Hz (HSC) or 20 Hz (normal ship speed).
Output
Data
Remote display signal HD, BP Trigger, Video
*: The output sentence, mode and baud rate can be set at the TT Preset menu.
5.2 Processor Unit
Input and output data are shown in the table below.
Input
Data
Heading signal
Speed signal
Navaid data
AIS signal
Alarm handling
signal
*: Data input cycle should be more than 40 Hz (HSC) or 20 Hz (normal ship speed).
NOTICE
Specification
sycrhro or step GC-10 required
AD-10 format External AD-100
IEC 61162-2*
Specification
Specification
IEC61162-2*
IEC 61162-1 Ed.4
IEC 61162-1 Ed.4 Position, time and
date, datum, course,
speed, wind, current,
depth, temperature,
NAVTEX, etc.
IEC 61162-2
Contact closure
IEC 61162-1 Ed.4
Contents
AD-10 and IEC 61162
are switched by menu
setting.
Contents
Contents
Input from alarm system
Input from alarm system
Remarks
Remarks
2 ports
Remarks
5-1