Table of Contents
Advertisement
• When you use IEC61162-450 compatible sensors, set [Transmission Group] on the
[Common Installation Settings] menu. See the Instruction Manual (E42-01204-*)
fordetails.
• When connecting two or more FAR-2xx7 series radars, via the HUB-3000, to a
FAR-3000 series radar, the HUB-3000 IGMP querier function must also be setup.
See the Instruction Manual for the HUB-3000 IGMP queirer.
Notice on wiring
• Use the optional USB cable (type: OP24-32) to connect to USB port on the control
unit.
• The length of the USB cable should be within 5 m to prevent equipment trouble.
• The length of LAN cables should be within 50 m.
• Use the CAT5E or CAT6 LAN cables for the network if available locally.
• If LAN cables are not available locally, use the optional LAN cables (FR-FTPC-CY
for sensor network, DTI-C5E350 VCV for gateway network).
• If extension or division of the DVI or ERGB cables is necessary, use the dividers
shown below.
• DVI cable divider: DVI-12A (maker: INAGICS)
• RGB divider: CIF-12H, DD-106 or WBD-14F (maker: INAGENICS)
• Make sure that the ground wires are connected between the ground terminals on
each equipment and the ship's earth.
• Pass the cables through the specified clamp or the locking wire saddle.
• If a UPS (user supply) is connected to this equipment, be sure that the grounding
lamp does not light.
2.2
Antenna Unit
2.2.1
FCR-2829W
he antenna unit requires the MPYCY-19 (Japan Industrial Standard cable) or equiva-
lent to connect to the transceiver unit RTR-081.
1. Remove the antenna covers.
2. Unscrew the clamping gland and take out the washers, rubber packing and cover.
3. Fabricate the cable as below.
Vinyl sheath
For not used cores, wind the vinyl tape around them to prevent the short circuit.
4. Slide the clamping gland, washer, gasket and washer in that order on to the cable.
5 mm
20 mm
450 mm
Vinyl sheath
Armor
6 mm
Core
Wind vinyl tape around
unused cores to insulate them.
2. WIRING
2-3
Hide quick links:
Advertisement
Table of Contents
