Figure 7 - St 700 Standard Transmitter - Inline Model Mounted To An Optional Bracket; Figure 8 - St 700 Standard Transmitter - Rotating The Electronics Housing - Honeywell ST 700 User Manual

Figure 7 – ST 700 Standard Transmitter - Inline Model Mounted to an Optional Bracket
3. Loosen the set screw on the outside neck of the Transmitter one (1) full turn.
4. Rotate the Electronics housing a maximum of 180
you require, and tighten the set screw using a 4mm metric socket head wrench. See the
following example and
Example: Rotating the Electronics Housing
Figure 8 – ST 700 Standard Transmitter - Rotating the Electronics Housing
The mounting position of AP models STA722 and STA72L becomes critical as the
Transmitter spans become smaller. A maximum zero shift of 2.5mmHg for these models can
result from a mounting position that is rotated 90o from the vertical.
A typical zero-shift of 0.12mmHg or 0.20 inH
the vertical.
Page 14
Figure 8.
2
ST 700 SmartLine Pressure Transmitters User's Manual
o
left or right from the center to the position
O can occur for a five (5)-degree rotation from
Revision 8.0