Flush Mounting; Torx Screwdriver; Mounting Location/Console - Furuno FMD3100 Installation Manual

1. MOUNTING
1.1.1

Flush mounting

Items to prepare for the flush mounting procedure:
• Torx screwdriver: T10, T25.
1. Attach the USB cable clamp to the PCU using the torx screws (M34, 2 pcs,
included).
2. Make a cutout where the PCU is to be located, referring to the outline drawings at
the back of this manual.
3. Connect all cables to their appropriate slot on the PCU. Take care to leave enough
slack in the cables to allow access for maintenance and repair.
4. Slide the unit into the cutout. Take care to not to bend or squash any cabling.
Note: User controls and ports should be facing downwards.
5. Taking care not to confuse the bracket types (see figure below), screw each back-
et into place, using M5x16 screws and C-washers.

Mounting location/console

6. Ensure all four sides are equally tight, taking care not to over-tighten the screws.
1-2
USB3
C4 C2
USB3 USB1 USB4
USB4 USB2
C3 C1
LAN2 LAN1
IEC61162-1/2
Mounting hole Mounting hole
Panel PC
Lower bracket is different from others
Mounting location/console
Bracket
C-washer
Screw
USB1
Attach the
USB2
USB cable
clamp here
LAN2 LAN1
Screw
Washer
Bracket
Panel PC
USB cable clamp