Fabricating Jis Cables; Fabrication Of Ttycs Series; Fabrication Of Ttycsla Series - Furuno FMD3100 Installation Manual

2.1.5

Fabricating JIS cables

Fabricate JIS cables as shown below to connect them to the WAGO connectors on
the PCU-3000 (See following page for WAGO connection).
After fabricating the cable, attach the WAGO connector and EMI ferrite core (sup-
plied). For how to attach the WAGO connecor and EMI ferrite core, see the next page.

Fabrication of TTYCS series

Armor
Vinyl tape (Width: 20)

Fabrication of TTYCSLA series

Armor
Vinyl tape (Width: 20)
Clamp here with cable clamp.
Sheath Shield
30
After exposing cores, wind shield
around the armor.
Clamp here with cable clamp.
*
100
5
Sheath
Drain wire
80
Pass a heat shrink tube (local supply) onto the
drain wire, then attach the crimp-on lug (supplied
with the PCU-3000) to it.
For flush mounted
installations, connect the
drain wire to this terminal.
C4 C2
C3 C1
IEC61162-1/2
USB3
USB1
USB4
USB2
LAN2 LAN1
NOTE: All dimension in millimeters
200
6
6
150
Crimp-on lug (supplied)
2. WIRING
2-7