Table of Contents
Advertisement
1.1.3
Flush mounting
For details, see the outline diagrams at the back of this manual.
For octagonal cutout
1. Make an octagonal cutout in the mounting location as shown in the illustration be-
low.
2. Make four pilot holes for self-tapping screws in the location indicated in the illus-
tration below.
3. Set the display unit to the cutout and fasten the display unit with four self-tapping
screws (φ5×20).
4. Set a cosmetic cap to each fixing hole on the front panel. (See "How to set the
cosmetic cap" on page 4.)
223±0.5 (8.78")
18 (0.71")
Pilot hole (4 places)
Cutout
For square cutout
You can install the display unit in a square cutout using with the optional kit OP26-28.
No.
1
Self-tapping screw 5×20 SUS304
2
Front fixing panel
3
Binding screw
4
Manual
1. Make a square cutout (239±1 mm) in the mounting location referring to the outline
drawing at the back of the manual.
2. Make four pilot holes for self-tapping screws in the location.
3. Attach the front fixing panel to the display unit from the front side with binding
screws (M5×16).
4. Set the display unit to the cutout and fasten the display unit with four self-tapping
screws (φ5×20) from the front side.
5. Set a cosmetic cap to each fixing hole on the front panel. (See "How to set the
cosmetic cap" on page 4.)
18 (0.71")
18 (0.71")
Front Fixing Panel OP26-28 (code no.: 001-247-250)
Name
Type
26-003-1701
M5×16 SUSU304 000-163-898-10
C72-01302-*
240 (9.45
"
)
Fixing hole (4-ø6)
Code no.
000-163-915-10
100-382-080-10
—
2
1. MOUNTING
12 (0.47
"
)
"
78 (3.07
)
Qty
Remarks
4
1
4
Hide quick links:
Advertisement
Table of Contents
