Desktop Mounting - Furuno FMD3100 Installation Manual

1.1.2 Desktop mounting (optional)
Items to prepare for the procedure:
• Torx screwdriver: T10, T25.
1. Attach the USB cable clamp to the PCU using the torx screws (M34, 2 pcs,
included).
2. Attach the brackets to the PCU-3000, referring to the figure below. It is essential
that the brackets are attached using the bottom screw holes, as shown in the
diagram below. Failure to do so will result in undue vibrations.
Bolt
Washer
Note: Ensure the PCU-3000 is placed face-down on a soft, clean area to avoid
damage to the screen.
3. Attach the cable clamp (OP24-39, supplied) to the rear of the PCU-3000 using the
screws (M612, 2 pcs., included in option kit).
4. Set the PCU in the desired installation location.
USB3
C4 C2
USB3 USB1 USB4
USB4 USB2
C3 C1
LAN2 LAN1
IEC61162-1/2
LAN2
Brackets
USB cable clamp
USB1
Attach the
USB2
USB cable
clamp here
LAN1
Screw
Cable clamp
1. MOUNTING
1-3