IBM Storwize V7000 Troubleshooting And Maintenance Manual page 149

Table 28. Error event IDs and error codes (continued)
Event Notification
ID type Condition
010030 E A managed disk error recovery procedure (ERP) has
occurred. The node or controller reported the following:
v Sense
v Key
v Code
v Qualifier
010031 E One or more MDisks on a controller are degraded.
010032 W The controller configuration limits failover.
010033 E The controller configuration uses the RDAC mode; this is
not supported.
010034 E Persistent unsupported controller configuration.
010040 E The controller system device is only connected to the
node through a single initiator port.
010041 E The controller system device is only connected to the
node through a single target port.
010042 E The controller system device is only connected to the
clustered system nodes through a single target port.
010043 E The controller system device is only connected to the
clustered system nodes through half of the expected
target ports.
010044 E The controller system device has disconnected all target
ports to the clustered system nodes.
010050 W A solid-state drive (SSD) failed. A rebuild is required.
010052 E A solid-state drive (SSD) is offline as a result of a drive
hardware error.
010053 E A solid-state drive (SSD) is reporting a predictive failure
analysis (PFA).
010054 E A solid-state drive (SSD) is reporting too many errors.
010055 W An unrecognized SAS device.
010056 E SAS error counts exceeded the warning thresholds.
010057 E SAS errors exceeded critical thresholds.
010058 E The drive initialization failed because of an unknown
block size or a block size that is not valid; an unknown
capacity or a capacity that is not valid; or was not able to
set the required mode pages.
010059 E A solid-state drive (SSD) is offline due to excessive
errors.
010060 E A solid-state drive (SSD) exceeded the warning
temperature threshold.
010061 E A solid-state drive (SSD) exceeded the offline
temperature threshold.
010062 E A drive exceeded the warning temperature threshold.
010063 W Drive medium error.
010066 W Controller indicates that it does not support descriptor
sense for LUNs that are greater than 2 TBs.
Error
code
1370
1623
1625
1624
1695
1627
1627
1627
1627
1627
1201
1205
1215
1215
1665
1216
1216
1661
1311
1217
1218
1217
1321
1625
Chapter 9. Event reporting
131