GE ÄKTAprocess Site Preparation Manual page 3

1 Introduction
Purpose of this document
The purpose of this document is to provide the information you need to fully prepare
your site for the installation and testing of the system.
A site preparation checklist is included in this document.
You must return this checklist to GE before GE Service personnel can install and test the
system.
Scope of this document
This Site Preparation Guide covers the ÄKTAprocess system.
Feedback to GE
Make sure to read the entire Site Preparation Guide and complete the Site preparation
checklist in Chapter 3.
Return the completed Site preparation checklist to the GE service office in your region.
You will find E-mail address and fax numbers to the GE service office in your region under:
www.gelifesciences.com/contact .
If your region is not listed, select the nearest region.
Assign personnel for site
preparation tasks
The site preparation tasks listed in the following table can be assigned to more than one
person at the customer site.
It is recommended that the same people assist the GE service personnel during the
subsequent installation process.
ÄKTAprocess Site Preparation Guide 29-1396-55 AA
WARNING
The product must be installed and prepared by GE personnel or a
third party authorized by GE.
1 Introduction
3