OPERATION
2. CHISEL AND BLADE SHARPENER
CAUTION:
THE TOOL IS RECOMMENDED FOR THE
USE WITH A RESIDUAL CURRENT DEVICE WITH A
RATED CURRENT OF 30mA OR LESS.
1 Install the chisel and blade
sharpener module.
3 Loosen the adjustable
angle knob and adjust the
angle to match the existing
bevelled angle on the tool.
5 Slide the blade rest back
and forth across the
sharpening wheel with light
steady pressure.
Note:
When sharpening narrow chisels or blades, place the narrow
tool guide onto the blade rest to act as a spacer and sharpen
as above.
2 Position the chisel or blade
on the blade rest. The
magnets will hold the blade
in position.
4 Turn on the sharpener by
pressing the on/off switch to
the on position "I".
I I
6 Gradually lower the blade
down the blade rest until
the tool is sharpened.
3. SHARPENING KNIVES
1 Install the knife and scissor
sharpener module.
2 Lower the handle end of the
knife into the sharpening
slot.
4 Insert the second side of
the blade into the opposite
sharpening slot and repeat
step 3.
2 Switch the sharpener on by
pressing the on/off switch
into the on position "I".
I I
3 Once the blade touches
the sharpening wheel, draw
the blade lightly across
the grinding wheel until
completely removed.
5 Repeat sharpening each
side until a clean, sharp
edge is achieved.
Need help?
Do you have a question about the MFS-4000 and is the answer not in the manual?
Questions and answers